Cisco Cisco Email Security Appliance C160 Références techniques

Commit: This command requires a ‘commit’.

Cluster Management: This command can be used in all three machine modes (cluster, group, machine).

Batch Command: This command does not support a batch format

In this example, a new configuration file is imported from a local location.

mail3.example.com> loadconfig

1. Paste via CLI

2. Load from file

[1]> 2

Enter the name of the file to import:

[]> changed.config.xml

Values have been loaded.

Be sure to run "commit" to make these settings active.

mail3.example.com> commit

Please enter some comments describing your changes:

[]> loaded new configuration file

Do you want to save the current configuration for rollback? [Y]> n

Changes committed: Fri May 23 11:42:12 2014 GMT

In this example, a new configuration file is pasted directly at the command line. (Remember to type 
Control-D on a blank line to end the paste command.) Then, the system setup wizard is used to change 
the default hostname, IP address, and default gateway information. Finally, the changes are committed.

mail3.example.com> loadconfig

1. Paste via CLI

2. Load from file

[1]> 1

Paste the configuration file now.

Press CTRL-D on a blank line when done.

</config>. Control-D is entered on a 

Values have been loaded.

Be sure to run "commit" to make these settings active.

mail3.example.com> systemsetup

mail3.example.com> commit

Please enter some comments describing your changes:

[]> pasted new configuration file and changed default settings via 

Do you want to save the current configuration for rollback? [Y]> n

Changes committed: Fri May 23 11:42:12 2014 GMT