Cisco Cisco Email Security Appliance C160 Références techniques

Cluster Management: This command is restricted to machine mode..

Batch Command: This command does not support a batch format.

In the following example, an older message is archived:

mail3.example.com> archivemessage

Enter the MID to archive.

[0]> 47

MID 47 has been saved in file oldmessage_47.mbox in the configuration

Configure Virtual Gateway(tm) mappings.

Commit: This command requires a ‘commit’.

Cluster Management: This command can be used in all three machine modes (cluster, group, machine).

Batch Command: This command does not support a batch format.

In the following example, the 

altsrchost

 table is printed to show that there are no existing mappings. 

Two entries are then created: 

Mail from the groupware server host named 

@exchange.example.com

 is mapped to the PublicNet 

interface.

Mail from the sender IP address of 192.168.35.35 is mapped to the AnotherPublicNet interface.

Finally, the 

altsrchost

 mappings are printed to confirm and the changes are committed.

mail3.example.com> altsrchost

There are currently no mappings configured.

Choose the operation you want to perform:

- NEW - Create a new mapping.

- IMPORT - Load new mappings from a file.

[]> new

Enter the Envelope From address or client IP address for which you want to set up a 

Virtual Gateway mapping.  Partial addresses such as "@example.com" or "user@" are allowed.

[]> @exchange.example.com

Which interface do you want to send messages for @exchange.example.com from?

1. AnotherPublicNet (192.168.2.2/24: mail4.example.com)

2. Management (192.168.42.42/24: mail3.example.com)