Cisco Cisco Email Security Appliance C160 Mode D'Emploi

(Optional) If you want to receive software release and critical support notification alerts from Cisco 
Support, check the Release and Support Notifications checkbox. 

Select the alert types and severities that this recipient will receive.

Submit and commit your changes.

The following settings apply to all alerts.

Use the 

alertconfig

 CLI command to define the number of alerts to save on the appliance to view later.

Click Edit Settings on the Alerts page. 

Enter a Header From: address to use when sending alerts, or select Automatically Generated 
(“alert@<hostname>”).

Mark the checkbox if you want to specify the number of seconds to wait between sending duplicate 
alerts. For more information, see 

Specify the initial number of seconds to wait before sending a duplicate alert.

Specify the maximum number of seconds to wait before sending a duplicate alert.

You can enable AutoSupport by checking the IronPort AutoSupport option. For more information about 
AutoSupport, see 

.

If AutoSupport is enabled, the weekly AutoSupport report is sent to alert recipients set to receive 
System alerts at the Information level. You can disable this via the checkbox.

Submit and commit your changes.

Alert settings control the general behavior and configuration of alerts, including:

The RFC 2822 Header From: when sending alerts (enter an address or use the default 
“alert@<hostname>”). You can also set this via the CLI, using the 

alertconfig -> from

 command.

The initial number of seconds to wait before sending a duplicate alert.

The maximum number of seconds to wait before sending a duplicate alert.

The status of AutoSupport (enabled or disabled).

The sending of AutoSupport’s weekly status reports to alert recipients set to receive System alerts 
at the Information level.