Cisco Cisco Email Security Appliance C160 Mode D'Emploi

The Cisco AsyncOS Command Line Interface is an interactive interface designed to allow you to 
configure and monitor the appliance. The commands are invoked by entering the command name with 
or without any arguments. If you enter the command without arguments, the command prompts you for 
the required information.

The Command Line Interface is accessible via SSH or Telnet on IP interfaces that have been configured 
with these services enabled, or via terminal emulation software on the serial port. By factory default, 
SSH and Telnet are configured on the Management port. Use the 

interfaceconfig 

command to disable 

these services.

For more information about specific CLI commands, see the Cisco AsyncOS CLI Reference Guide.

This section describes the rules and conventions of the AsyncOS CLI.

The top-level command prompt consists of the fully qualified hostname, followed by the greater than (

>

) 

symbol, followed by a space. For example:

If the appliance has been configured as part of a cluster, the prompt in the CLI changes to indicate the 
current mode. For example: 

or 

See 

 for more information. 

When running commands, the CLI requires input from you. When the CLI is expecting input from you, 
the command prompt shows the default input enclosed in square brackets (

[]

) followed by the greater 

than (

>

) symbol. When there is no default input, the command-prompt brackets are empty. 

mail3.example.com> 

(Cluster Americas) > 

(Machine losangeles.example.com) >