Cisco Cisco Email Security Appliance C160 Mode D'Emploi

For example, uploading this: 

will remove all listeners from the system!

When uploading or pasting subsections of a configuration file, you have the potential to disconnect 
yourself from the GUI or CLI and to destroy large amounts of configuration data. Do not disable services 
with this command if you are not able to reconnect to the appliance using another protocol, the Serial 
interface, or the default settings on the Management port. Also, do not use this command if you are 
unsure of the exact configuration syntax as defined by the DTD. Always back up your configuration data 
prior to loading a new configuration file. 

If you attempt to load a configuration file that contains a log subscription that requires a password (for 
example, one that will use FTP push), the 

loadconfig

 command does not warn you about the missing 

password. The FTP push will fail and alerts will be generated until you configure the correct password 
using the 

logconfig

 command. 

The “encoding” attribute of the XML configuration file must be “

ISO-8859-1

” regardless of the 

character set you may be using to manipulate the file offline. Note that the encoding attribute is specified 
in the file whenever you issue the 

showconfig

, 

saveconfig

, or 

mailconfig

 commands: 

Currently, only configuration files with this encoding can be loaded. 

Resetting the current configuration causes your appliance to revert back to the original factory defaults. 
You should save your configuration prior to resetting it. Resetting the configuration via this button in the 
GUI is not supported in a clustering environment.

See 

The following commands allow you to manipulate the configuration files: 

showconfig

mailconfig

saveconfig

loadconfig

resetconfig

 (See 

.) 

<?xml version="1.0" encoding="ISO-8859-1"?>