Cisco Cisco Email Security Appliance C160 Mode D'Emploi

Page de 568
2-51
Cisco IronPort AsyncOS 7.5 for Email Advanced Configuration Guide
OL-25137-01
Chapter 2      Configuring Routing and Delivery Features
Hard Bounces and the status Command
When hard bounce message generation is enabled, the following counters in the 
status
 and 
status detail 
commands increment each time the appliance 
generates a hard bounce message for delivery:
Use DomainKeys 
signing for 
bounce and 
delay messages
You can select a DomainKeys profile to use for signing bounce 
and delay messages. For information on DomainKeys, see 
Global Settings
Configure these settings via the Edit Global Settings link on the Bounce Profiles page or 
by editing the default bounce profile via the 
bounceconfig
 command in the CLI.
Initial number of 
seconds to wait 
before retrying 
an unreachable 
host
The amount of time the system should wait before
retrying a host that is unreachable. The default is 60 seconds. 
Max interval 
allowed between 
retries to an 
unreachable host
The maximum amount of time the system should wait before 
retrying a host that is unreachable. The default is 3,600 
seconds (1 hour). When the delivery initially fails due to the 
host being down, it will start with the minimum number of 
seconds retry value, and for each subsequent retry to the 
downed host, will increase the duration, up to this maximum 
number of seconds value.
Table 2-5
Bounce Profile Parameters  (Continued)
Counters:                         Reset          Uptime        Lifetime
    Receiving
    Messages Received           0             0             0
    Recipients Received         0             0             0
    Gen. Bounce Recipients      0             0             0