Cisco Cisco Email Security Appliance X1070 Mode D'Emploi

In following example, the 

interfaceconfig

 command is used to edit the IP 

interface PublicNet to enable HTTPS services on port 443 (the default port). All 
other defaults for the interface are accepted. (Typing Enter at the prompt accepts 
the default value shown in brackets.)

Note that this example shows using the demonstration certificate that is 
pre-installed on the appliance. You may enable HTTPS services with the 
demonstration certificate for testing purposes, but it is not secure and is not 
recommended for general use.

You can enable HTTPS services using the System Setup Wizard in the GUI. Refer 
to “Define the Default Router (Gateway), Configure the DNS Settings, and 
Enabling Secure Web Access” in the “Setup and Installation” chapter of the Cisco 
IronPort AsyncOS for Email Configuration Guide. 

After the changes from this command are committed, users can access the 
Graphical User Interface (GUI) using the URL for secure HTTPS: 

https://192.168.2.1

mail3.example.com> interfaceconfig

Currently configured interfaces:

1. Management (192.168.42.42/24: mail3.example.com)

2. PrivateNet (192.168.1.1/24: mail3.example.com)

3. PublicNet (192.168.2.1/24: mail3.example.com)

Choose the operation you want to perform:

- NEW - Create a new interface.

- EDIT - Modify an interface.

- GROUPS - Define interface groups.