Cisco Cisco Email Security Appliance C160 Mode D'Emploi
3-13
Cisco IronPort AsyncOS 7.6 for Email Configuration Guide
OL-25136-01
Chapter 3 Setup and Installation
Using the System Setup Wizard
The Cisco IronPort AsyncOS operating system provides a browser-based System Setup Wizard to guide
you through the five step process of system configuration. Also included is a command line interface
(CLI) version of the System Setup Wizard. See
you through the five step process of system configuration. Also included is a command line interface
(CLI) version of the System Setup Wizard. See
for more information. Some users will want to take advantage of custom
configuration options not available in the System Setup Wizard. However, you must use the System
Setup Wizard for the initial setup to ensure a complete configuration. If you have gathered the
information required in
Setup Wizard for the initial setup to ensure a complete configuration. If you have gathered the
information required in
, the configuration process will take less time to
complete.
Warning
The System Setup Wizard will completely reconfigure your system. You should only use the System
Setup Wizard the very first time you install the appliance, or if you want to completely overwrite your
existing configuration.
Setup Wizard the very first time you install the appliance, or if you want to completely overwrite your
existing configuration.
Warning
The Cisco IronPort appliance ships with a default IP address of
192.168.42.42
on the Management
port of C650/660/670, C350/360/370, and X1050/1060/1070 systems, and the Data 1 port of C150/160
systems. Before connecting the Cisco IronPort appliance to your network, ensure that no other
device’s IP address conflicts with this factory default setting. If you are configuring a Cisco IronPort
M-Series appliance, please see
systems. Before connecting the Cisco IronPort appliance to your network, ensure that no other
device’s IP address conflicts with this factory default setting. If you are configuring a Cisco IronPort
M-Series appliance, please see
.
If you are connecting multiple factory-configured Cisco IronPort appliances to your network, add them
one at a time, reconfiguring each Cisco IronPort appliance’s default IP address as you go.
one at a time, reconfiguring each Cisco IronPort appliance’s default IP address as you go.
Accessing the Web-Based Graphical User Interface (GUI)
To access the web-based Graphical User Interface (GUI), open your web browser and point it to
192.168.42.42.
192.168.42.42.
The login screen is displayed:
Figure 3-4
Logging in to the Appliance
Log in to the appliance by entering the username and password below.
Sophos Anti-Virus Scanning Engine
Enable / Disable
Outbreak Filters
Enable / Disable
Table 3-4
System Setup Worksheet: 1 Listener for All Email Traffic (Continued)