Cisco Cisco Email Security Appliance C160 Mode D'Emploi

You can make configuration changes to IronPort AsyncOS while email operations 
proceed normally. 

Configuration changes will not take effect until you:

Issue the 

commit

 command at the command prompt.

Give the 

commit

 command the input required.

Receive confirmation of the 

commit

 procedure at the CLI.

Changes to configuration that have not been committed will be recorded but not 
put into effect until the 

commit

 command is run. 

Not all commands in AsyncOS require the 

commit

 command to be run. See 

Appendix A, “AsyncOS Quick Reference Guide,” in the Cisco IronPort AsyncOS 
for Email Advanced Configuration Guide

 

or view the Cisco IronPort AsyncOS 

CLI Reference Guide for a summary of commands that require commit to be run 
before their changes take effect. 

Exiting the CLI session, system shutdown, reboot, failure, or issuing the 

clear

 

command clears changes that have not yet been committed.

This section describes the commands used to commit or clear changes, to get help, 
and to quit the command-line interface.

The 

commit

 command is critical to saving configuration changes to the IronPort 

appliance. Many configuration changes are not effective until you enter the 

commit

 command. (A few commands do not require you to use the 

commit

 

command for changes to take effect. See Appendix A, “AsyncOS Quick Reference 
Guide,” in the Cisco IronPort AsyncOS for Email Advanced Configuration Guide 
for more information. The 

commit

 command applies configuration changes made