Cisco Cisco Email Security Appliance C160 Mode D'Emploi

Your IronPort appliance is now ready to send email.

Clicking Install will cause the connection to the current URL 
(http://192.168.42.42) to be lost if you changed the IP address of the interface you 
used to connect to the appliance (the Management interface on X1000/1050/1060, 
C60/600/650/660, and C30/300/350/360 systems, or the Data 1 interface on 
C10/100/150/160 systems) from the default. However, your browser will be 
redirected to the new IP address. 

Once System Setup is complete, several alert messages are sent. See 

 for more information. 

If the System Setup Wizard properly installs the configuration on the Email 
Security appliance, the Active Directory Wizard appears. If you are running an 
Active Directory server on your network, use the Active Directory Wizard to 
configure an LDAP server profile for the Active Directory server and assign a 
listener for recipient validation. If you are not using Active Directory or want to 
configure it later, click Skip this Step. You can run the Active Directory Wizard 
on the System Administration > Active Directory Wizard page. You can also 
configure Active Directory and other LDAP profiles on the System 
Administration > LDAP page.

The Active Directory Wizard retrieves the system information needed to create an 
LDAP server profile, such as the authentication method, the port, the base DN, 
and whether SSL is supported. The Active Directory Wizard also creates LDAP 
accept and group queries for the LDAP server profile.