Cisco Cisco TelePresence MX700 Guide De Montage
Configuration using the remote
control and on-screen menu*
Waking up the system
if there is no menu on screen, press
Home
( )
on the remote
control to show the menu.
if the system does not show a menu on screen:
• Make sure the monitor is connected and has been switched
on.
• Make sure the remote control has batteries installed.
• Make sure the system is switched on.
• Make sure the system is switched on.
if the system has just been switched on, wait a few minutes
to allow the system to start up.
if there is still no menu on screen, make sure the
monitor cable is connected to the basic video
output. connector. if in doubt, see the installation guide for
your product.
* this section does not apply for eX and MX series.
Remote control and
on-screen menu
Back to task overview
Cisco TelePresence Video Systems
D14639.09 Video Systems Getting Started Guide TC6.1, April 2013.
Copyright © 2010–2013 Cisco Systems, Inc. All rights reserved.
17
Getting Started Guide
Contents
Introduction
User interfaces
Configuration
Appendices
Contacts
Confirguration