Cisco Cisco TelePresence MX700 Fascicule
695: Which configurations on my video system require a reboot to take effect?
The following configurations require a reboot to take effect:
TC5:
TC5:
y
xConfiguration NetworkServices HHTP Mode
y
xConfiguration NetworkServices HHTPS Mode
y
xConfiguration RTP Ports Range Start
y
xConfiguration RTP Ports Range Stop
y
xConfiguration Network 1 Speed
y
xConfiguration Network 1 IPStack (when switching from IPv4 to IPv6; not from IPv6
to IPv4)
y
xConfiguration Security Audit Server Address
y
xConfiguration Security Audit Server Port
y
xConfiguration Security Audit OnErrorAction
y
xConfiguration Security Audit Logging Mode
y
xConfiguration Network Port 2 Mode: Requires reboot
TC6:
y
xConfiguration NetworkServices HHTP Mode
y
xConfiguration NetworkServices HHTPS Mode
y
xConfiguration RTP Ports Range Start
y
xConfiguration RTP Ports Range Stop
y
xConfiguration Security Audit Server Address
y
xConfiguration Security Audit Server Port
y
xConfiguration Security Audit OnErrorAction
y
xConfiguration Security Audit Logging Mode
y
xConfiguration Network Port 2 Mode: Requires reboot
TC7:
y
xConfiguration RTP Ports Range Start
y
xConfiguration RTP Ports Range Stop
y
xCommand SystemUnit ConfigurationProfile Change
Applies to the following products:
y
SX20 Quick Set
y
Codec C20
y
Codec C40
y
Codec C60
y
Codec C90
y
MX200
y
MX300
y
MX200 G2
y
MX300 G2
y
MX700
y
MX800
y
EX60
y
EX90
696: What kind of external speakers can I use with the C20 and SX20 codecs?
You should use active speakers that are non-grounded. Attaching a grounded active speaker
to the system creates a ground loop, which causes an annoying humming sound.
Another option is to use a ground isolator between grounded speakers and the codec.
Applies to the following products:
y
SX20 Quick Set
y
Codec C20
697: How can I set up self view in full screen mode on my secondary monitor?
This is possible with TC6.0, and later software versions. To achieve this, use the following
configurations:
1. xConfiguration Video SelfviewDefault OnMonitorRole: second
2. xConfiguration Video SelfviewDefault FullscreenMode:on
To change the configurations on the web interface, go to
Configuration > System Configuration
> Video > SelfviewDefault
. From
OnMonitorRole
select
Second
and from
FullscreenMode
select
On
. Click
Save
to confirm the changes.
Applies to the following products:
y
SX20 Quick Set
y
SX80
y
Codec C20
y
Codec C40
y
Codec C60
y
Codec C90
y
MX200
y
MX300
y
MX200 G2
y
MX300 G2
y
MX700
y
MX800
y
EX60
y
EX90
Cisco TelePresence TC Endpoints
D14865.03 TC Endpoints Knowledge Base Articles | APRIL 2015
Copyright © 2011–2013 Cisco Systems, Inc. All rights reserved.
25
Knowledge Base Articles
Contents
Introduction
Questions
Contact
Questions and answers
Appendices
Questions and answers