Cisco Cisco 521 Wireless Express Access Point
3
Release Notes for Cisco 521 Wireless Express Standalone Access Point for Cisco IOS Release 12.4(10b)JX
OL-15365-01
Installation Notes
Warnings
This section contains safety warnings for the AAP521. For translated warnings, refer to the Translated
Safety Warnings for Cisco Aironet Access Points document at the following URL:
Safety Warnings for Cisco Aironet Access Points document at the following URL:
Warning
This product must be connected to a Power-over-Ethernet (PoE) IEEE 802.3af compliant power source
or an IEC60950 compliant limited power source. Statement 353
or an IEC60950 compliant limited power source. Statement 353
Warning
In order to comply with FCC radio frequency (RF) exposure limits, antennas should be located a
minimum of 7.9 in. (20 cm) or more from the body of all persons. Statement 332
minimum of 7.9 in. (20 cm) or more from the body of all persons. Statement 332
Warning
Do not operate your wireless network device near unshielded blasting caps or in an explosive
environment unless the device has been modified to be especially qualified for such use.
Statement 245b
environment unless the device has been modified to be especially qualified for such use.
Statement 245b
Warning
Do not work on the system or connect or disconnect cables during periods of lightning activity.
Statement 1004
Statement 1004
Warning
Read the installation instructions before you connect the system to its power source.
Statement 1004
Statement 1004
Warning
This product relies on the building’s installation for short-circuit (overcurrent) protection. Ensure that
the protective device is rated not greater than 20A. Statement 1005
the protective device is rated not greater than 20A. Statement 1005
Safety Information
Follow the guidelines in this section to ensure proper operation and safe use of AAP521.
FCC Safety Compliance Statements
The FCC, with its action in ET Docket 96-8, has adopted a safety standard for human exposure to RF
electromagnetic energy emitted by FCC-certified equipment. Cisco 521 standalone access points meet
the uncontrolled environmental limits found in OET-65 and ANSI C95.1, 1991. Proper operation of this
radio device according to the instructions in this document and the installation and configuration guides
will result in user exposure substantially below the FCC recommended limits.
electromagnetic energy emitted by FCC-certified equipment. Cisco 521 standalone access points meet
the uncontrolled environmental limits found in OET-65 and ANSI C95.1, 1991. Proper operation of this
radio device according to the instructions in this document and the installation and configuration guides
will result in user exposure substantially below the FCC recommended limits.
•
Do not hold any component containing a radio such that the antenna is very close to or touching any
exposed parts of the body, especially the face or eyes, while transmitting.
exposed parts of the body, especially the face or eyes, while transmitting.
•
The use of wireless devices in hazardous locations is limited to the constraints posed by the safety
directors of such environments.
directors of such environments.