Cisco Cisco SG200-26P 26-port Gigabit PoE Smart Switch Manuel De Maintenance
Administration
Configuring Control Packet Forwarding
Cisco Small Business SF200E Series Advanced Smart Switch
82
3
STEP 3
For an IPv4 address, enter the following parameters:
•
IP Address/Hostname—Enter the IP address or the hostname of the station
you want the switch to ping.
you want the switch to ping.
•
Count—Specify the number of pings to send.
•
Interval—Specify the number of seconds between pings sent.
•
Datagram Size—Specify the data size of the ping packet to send.
For an IPv6 address, enter the following parameters:
•
Ping Type—Select Global to ping an address outside the local subnet.
Select Link Local to ping an address on the local subnet.
Select Link Local to ping an address on the local subnet.
•
IPv6 Address/Hostname—(Global addresses only) Enter the 128-bit global
address.
address.
•
IPv6 Link-Local Address—(Link-local addresses only) Enter the link local
address if the address is on the same subnet as the switch.
address if the address is on the same subnet as the switch.
•
Datagram Size—Specify the data size of the ping packet to send (between
48 and 2048 bytes).
48 and 2048 bytes).
STEP 4
Click Apply to send the ping. You can view the status in the Ping window.
Configuring Control Packet Forwarding
You can use the Control Packet Forwarding page to configure how the switch
handles packets of the following protocol types:
handles packets of the following protocol types:
•
CDP—The Cisco Discovery Protocol (CDP), which is supported on many
types of Cisco networking equipment. CDP enables directly connected
devices to share information such as their IP addresses, capabilities, and
software versions. Although the switch does not itself support CDP, it can
forward CDP packets on behalf of connected devices within a VLAN.
types of Cisco networking equipment. CDP enables directly connected
devices to share information such as their IP addresses, capabilities, and
software versions. Although the switch does not itself support CDP, it can
forward CDP packets on behalf of connected devices within a VLAN.
•
Dot1X—The IEEE 802.1X protocol defines how Extensible Authentication
Protocol (EAP) packets are encapsulated over a LAN. Dot1X provides a way
to authenticate users and allow or deny them access to services made
available by switch ports. See 802.1X for information on configuring the
Dot1X feature on the switch.
Protocol (EAP) packets are encapsulated over a LAN. Dot1X provides a way
to authenticate users and allow or deny them access to services made
available by switch ports. See 802.1X for information on configuring the
Dot1X feature on the switch.