Cisco Cisco SG200-26P 26-port Gigabit PoE Smart Switch
Release Notes for 200, 300, 500, and ESW2 Series Switches Firmware Version 1.3.0
7
Release Notes
Major Changes and Defects Corrected
Major Changes
•
Added support for RMON History, Events and Alarms for the 200 Series
Switches.
Switches.
•
Added Basic Hybrid and Advanced Hybrid modes for stacking.
•
Added Unicast SNTP Server time synchronization.
•
Added the SCP option for the 200 Series Switches.
•
Reorganized the web-based administration by adding the System Object
ID and SNMP Service to the Sx300 System Summary page in System
Information. Removed the TCAM Allocation page and added the Router
Resources page.
ID and SNMP Service to the Sx300 System Summary page in System
Information. Removed the TCAM Allocation page and added the Router
Resources page.
•
Added support to the 200 Series Switches for Root Guard and BPDU Guard
with Spanning Tree.
with Spanning Tree.
•
Added several IPv6 improvements.
•
Added support for SNMP and SSH to the 200 Series Switches.
•
Updated DSCP to Queue to 8 queues where relevant.
•
DHCPv4 Server
•
IPv6 Routing on the 500 series
•
Larger table sizes
•
Safari and Chrome Browser support
•
IPv6 enhancements
Defects Corrected
•
On the 500X series of switches, the Port Speed display was shown as
"unknown" on the web-based interface when the uplink ports were enabled
with 10 GIG speed. (CQ142146)
"unknown" on the web-based interface when the uplink ports were enabled
with 10 GIG speed. (CQ142146)
•
When a device was in Layer 3 mode and received an IP address from a
DHCP server, if the user changed the IP address to static, it would not be
DHCP server, if the user changed the IP address to static, it would not be