Cisco Cisco Packet Data Gateway (PDG) Guide De Dépannage
APN Configuration Mode Commands
▀ accounting-mode
▄ Cisco ASR 5000 Series Command Line Interface Reference
OL-22947-02
Disables the generation of RADIUS interims per APN. If
is specified, then it won't send any
RADIUS INTERIM-UPDATEs for this APN, regardless of what is configured in the context that is used for
RADIUS accounting.
RADIUS accounting.
Usage
This command specifies which protocol, if any, will be used to provide accounting for PDP contexts
accessing the APN profile.
When the GTPP protocol is used, accounting messages are sent to the charging gateways (CGs) over the Ga
interface. The Ga interface and GTPP functionality are typically configured within the system‘s source
context. As specified by the standards, a CDR is not generated when a session starts - CDRs are generated
according to the interim triggers (configured using the cc command in the GGSN service configuration mode)
and a CDR is generated when the session ends. For interim accounting, STOP/START pairs are sent based on
configured triggers.
GTPP version 2 is always used. However, if version 2 is not supported by the CGF, the system reverts to
using GTPP version 1. All subsequent CDRs are always fully-qualified partial CDRs. All CDR fields are R4.
If the
accessing the APN profile.
When the GTPP protocol is used, accounting messages are sent to the charging gateways (CGs) over the Ga
interface. The Ga interface and GTPP functionality are typically configured within the system‘s source
context. As specified by the standards, a CDR is not generated when a session starts - CDRs are generated
according to the interim triggers (configured using the cc command in the GGSN service configuration mode)
and a CDR is generated when the session ends. For interim accounting, STOP/START pairs are sent based on
configured triggers.
GTPP version 2 is always used. However, if version 2 is not supported by the CGF, the system reverts to
using GTPP version 1. All subsequent CDRs are always fully-qualified partial CDRs. All CDR fields are R4.
If the
option is used, either the RADIUS or the Diameter protocol is used as
configured in the Context Configuration mode or the AAA Server Group Configuration mode.
If the RADIUS protocol is used, accounting messages can be sent over a AAA interface or the Gi to the
RADIUS server. The AAA or Gi interface(s) and RADIUS functionality are typically configured with the
system‘s destination context along with the APN. RADIUS accounting begins immediately after an IP
address is allocated for the MS. Interim accounting can be configured using the
If the RADIUS protocol is used, accounting messages can be sent over a AAA interface or the Gi to the
RADIUS server. The AAA or Gi interface(s) and RADIUS functionality are typically configured with the
system‘s destination context along with the APN. RADIUS accounting begins immediately after an IP
address is allocated for the MS. Interim accounting can be configured using the
. The
command sends INTERIM-
UPDATE messages at specific intervals.
Keywords to this command can be used in combination to each other, depending on configuration
requirements.
Keywords to this command can be used in combination to each other, depending on configuration
requirements.
Important:
If the accounting type in the APN is set to ‗none‘ then G-CDRs will not be generated. If accounting
type is left as default ―GTPP‖ and ―billing-records‖ are configured in the ACS Rulebase Configuration Mode, then both
G-CDRs and eG-CDRs would be generated.
G-CDRs and eG-CDRs would be generated.
Example
The following command configures the APN to use the RADIUS/Diameter protocol for accounting:
The following command configures the APN to use the RADIUS/Diameter protocol for accounting: