Cisco Cisco Packet Data Gateway (PDG) Guide De Dépannage
Global Configuration Mode Commands
threshold per-service-sgsn-sessions ▀
Cisco ASR 5000 Series Command Line Interface Reference ▄
OL-22947-02
threshold per-service-sgsn-sessions
Configures the thresholds for the number of 3G-attached subscribers per SGSN service in the system.
Product
SGSN
Privilege
Security Administrator, Administrator
Syntax
Default: 0
The high threshold number of 3G-attached subscribers for any one SGSN service. This number must be met
or exceeded within the polling interval to generate an alert or alarm.
The number can be configured to any integer value from 0 through 2000000. A value of 0 disables the
threshold.
The high threshold number of 3G-attached subscribers for any one SGSN service. This number must be met
or exceeded within the polling interval to generate an alert or alarm.
The number can be configured to any integer value from 0 through 2000000. A value of 0 disables the
threshold.
Default: 0
The low threshold number of 3G-attached subscribers for any one SGSN service. This number must be met or
exceeded to maintain a previously generated alarm condition. If the number of subscribers falls beneath the
low threshold within the polling interval, a clear alarm will be generated.
The number can be configured to any integer value between 0 and 2000000. A value of 0 disables the
threshold.
The low threshold number of 3G-attached subscribers for any one SGSN service. This number must be met or
exceeded to maintain a previously generated alarm condition. If the number of subscribers falls beneath the
low threshold within the polling interval, a clear alarm will be generated.
The number can be configured to any integer value between 0 and 2000000. A value of 0 disables the
threshold.
Important:
This value is ignored for the Alert model. In addition, if this value is not configured for the Alarm
model, the system assumes it is identical to the high threshold.
Usage
Monitor and set alarms or alerts when the number of 3G-attached subscribers for any one SGSN service in
the system is equal to or greater than the set limit.
Alerts or alarms are triggered for PDP contexts based on the following rules:
the system is equal to or greater than the set limit.
Alerts or alarms are triggered for PDP contexts based on the following rules:
Enter condition: Actual number of 3G-attached subscribers for any single SGSN service ³ High
Threshold
Clear condition: Actual number of 3G-attached subscribers for any single SGSN service < Low
Threshold
If a trigger condition occurs within the polling interval, the alert or alarm will not be generated until the end
of the polling interval.
Refer to the
of the polling interval.
Refer to the
command to configure the polling interval and the
command to enable thresholding for this value.
Example