Cisco Cisco Packet Data Interworking Function (PDIF) Guide De Dépannage
Channelized Port Configuration Mode Commands
path ▀
Cisco ASR 5000 Series Command Line Interface Reference ▄
OL-22947-02
Defines up to 8 timeslot groupings for multiple fractional DS1/E1 channels. Each slot is 2.048/32 Mbytes.
Slots 0 and 16 are reserved for synchronization and alarms. Slots 1-15 and 17-31 are used for data. Timeslots
must be unique -- a timeslot can not be used in more than one grouping.
Slots 0 and 16 are reserved for synchronization and alarms. Slots 1-15 and 17-31 are used for data. Timeslots
must be unique -- a timeslot can not be used in more than one grouping.
Must be an integer from 1 to 31. Timeslot groups are separated by spaces and can consist of a
single slot and/or a range indicated with a hyphen. Example: 3,7-10 is a single fractional group. NOTE there
is no space after the comma. Timeslots must be unique -- a timeslot can not be used in more than one
grouping.
is no space after the comma. Timeslots must be unique -- a timeslot can not be used in more than one
grouping.
Enables definition of a Frame Relay connection with the
command.
Important:
For release 8.1 and higher, this feature has been moved to the
command.
Selecting the interface type specifies signaling parameters for the DLCI, options include:
: Selects data circuit-terminating equipment -type signaling.
: Selects data terminal equipment -type signaling.
: Selects the network-to-network interface
Default: DTE for Release 8.0
Default: DCE for Release 8.1
Default: DCE for Release 8.1
Important:
For release 8.1 and higher, this feature has been moved to the
command.
Default:
.
Line management type options include:
- ANSI ANNEXED LMI, may include option:
- Cisco/Gang Of Four LMI
- LMI Disabled
- Q.933A LMI
Any of the above LMI types can take one or more additional options
- Number of keep exchanges before requesting a full status message. Default is 6.
must be an integer from 1 to 255.
- Error Threshold value. Default is 2.
must be an integer from 1 to 10.
- Monitored events count value. Default is 2.
must be an integer from 1 to 10.
- Timer to send messages. Default is 10.
must be an integer from 5 to 30.
- Polling verification timer value. Default is 15.
must be an integer from 5 to 30.
Important:
For release 8.1 and higher, this feature has been moved to the
command.