Cisco Cisco Tunnel Terminating Gateway (TTG) Guide De Dépannage
CSCF Service Configuration Mode Commands
▀ nat-policy
▄ Cisco ASR 5000 Series Command Line Interface Reference
OL-22947-02
Usage
Generally, if a SIP packet has a VIA address (physical address that identifies where the service is located)
different from the Source address, ALG functionality is invoked. Even if the VIA and Source addresses are
the same, however, this command allows the ALG functionality to be started. For ALG to start, the VIA
address should belong to one of the nat-policy address ranges.
different from the Source address, ALG functionality is invoked. Even if the VIA and Source addresses are
the same, however, this command allows the ALG functionality to be started. For ALG to start, the VIA
address should belong to one of the nat-policy address ranges.
Example
The following command identifies the NAT policy named
The following command identifies the NAT policy named
with a private-address policy type of
:
The following command identifies the NAT policy named
with a private-address range policy type of
:
The following command identifies the NAT policy named
with a default policy type: