Cisco Cisco Tunnel Terminating Gateway (TTG) Guide De Dépannage
CSCF Service Configuration Mode Commands
policy ▀
Cisco ASR 5000 Series Command Line Interface Reference ▄
OL-22947-02
Use this command to set QoS support during either the initial SDP response or the 200OK response to the
INVITE. When this CLI is enabled, QoS commit is done during initial SDP answer. When disabled, QoS
commit is done during 200OK INVITE. By default, this command is enabled.
In addition, thresholds dictate the conditions for which congestion control is to be enabled and establish limits
for defining the state of the CSCF service (congested or clear). The tolerance parameter establishes the
threshold at which the condition is cleared.
INVITE. When this CLI is enabled, QoS commit is done during initial SDP answer. When disabled, QoS
commit is done during 200OK INVITE. By default, this command is enabled.
In addition, thresholds dictate the conditions for which congestion control is to be enabled and establish limits
for defining the state of the CSCF service (congested or clear). The tolerance parameter establishes the
threshold at which the condition is cleared.
Important:
When congestion is triggered, new CSCF calls are not rejected.
Example
The following command sets the upper threshold for CPU utilization for triggering congestion control at
The following command sets the upper threshold for CPU utilization for triggering congestion control at
.
The following command sets the tolerance to its default value of .