Cisco Cisco Tunnel Terminating Gateway (TTG) Guide De Dépannage
IPv6 ACL Configuration Mode Commands
▀ readdress server
▄ Cisco ASR 5000 Series Command Line Interface Reference
OL-22947-02
The IP address(es) form which the packet originated.
This option is used to filter all packets from a specific IP address or a group of IP addresses.
When specifying a group of addresses, the initial address is configured using this option. The range can then
be configured using the
This option is used to filter all packets from a specific IP address or a group of IP addresses.
When specifying a group of addresses, the initial address is configured using this option. The range can then
be configured using the
parameter.
Specifies that the rule applies to all packets.
Specifies that the rule applies to a specific host as determined by its IP address.
The IP address of the source host to filter against expressed in IPv6 colon notation.
The IP address of the destination host to filter against expressed in IPv6 colon notation.
Specifies a single, specific source TCP port number to be filtered.
must be configured to any integer value from 0 to 65535.
Specifies that all source TCP port numbers greater than the one specified are to be filtered.
must be configured to any integer value from 0 to 65535.
Specifies that all source TCP port numbers less than the one specified are to be filtered.
must be configured to any integer value from 0 to 65535.
Specifies that all source TCP port numbers not equal to the one specified are to be filtered.
must be configured to any integer value from 0 to 65535.
The IP address(es) to which the packet is to be sent.
This option is used to filter all packets to a specific IP address or a group of IP addresses.
When specifying a group of addresses, the initial address is configured using this parameter. The range can
then be configured using the
This option is used to filter all packets to a specific IP address or a group of IP addresses.
When specifying a group of addresses, the initial address is configured using this parameter. The range can
then be configured using the
parameter.
Specifies a single, specific destination TCP port number to be filtered.
must be configured to any integer value from 0 to 65535.
Specifies that all destination TCP port numbers greater than the one specified are to be filtered.