Cisco Cisco Aironet 1400 Wireless Bridge
4
Release Notes for Cisco Aironet 1410 Bridges for Cisco IOS Release 12.2(13)JA4
OL-5848-02
Important Notes
In Install Automatic Mode, the default distance setting is 99 km. When you change the role in radio
network from Install Automatic Mode to Root or Non-Root, the distance setting changes automatically
from 99 km to 0 km.
network from Install Automatic Mode to Root or Non-Root, the distance setting changes automatically
from 99 km to 0 km.
Cisco Aironet Software Requires Completion of Encryption Authorization Form
To access Cisco Aironet software from the Software Center on Cisco.com, you must now fill out a form
to receive authorization to download encrypted software. Registered Cisco.com users are required to fill
out the form only once, but public users must do so once each session, each time software is downloaded.
A form is automatically created for public users. The form for Registered Cisco.com users is located at
the following URL:
to receive authorization to download encrypted software. Registered Cisco.com users are required to fill
out the form only once, but public users must do so once each session, each time software is downloaded.
A form is automatically created for public users. The form for Registered Cisco.com users is located at
the following URL:
Default Encryption Key 2 Is Set by Bridge
The encryption key in slot 2 is the transmit key by default. If you enable WEP with MIC, use the same
WEP key as the transmit key in the same key slot on both root and non-root bridges.
WEP key as the transmit key in the same key slot on both root and non-root bridges.
Limitation to PAgP Redundancy on Switches Connected by Bridge Links
When two switches configured for Port Aggregation Protocol (PAgP) are connected by redundant
wireless bridge links, the PAgP switchover takes at least 30 seconds, which is too slow to maintain TCP
sessions from one port to another.
wireless bridge links, the PAgP switchover takes at least 30 seconds, which is too slow to maintain TCP
sessions from one port to another.
power client n CLI Command Is Not Supported
The bridge does not support the power client n command in the browser or CLI interfaces.
bridge(config-if)# power client n
(where n is a value of 12, 15, 18, 21, 22, 23, 24, or maximum)
The bridge does not perform any action when you enter this command.
Default Infrastructure SSID
When VLAN is enabled, the WEP encryption mode and the WEP key are applicable only to a native VLAN.
Any SSID configured should have the Infrastructure-SSID parameter enabled for that SSID. With the
Infrastructure-SSID parameter enabled, the bridge ensures that a non-native VLAN cannot be assigned
to that SSID.
Any SSID configured should have the Infrastructure-SSID parameter enabled for that SSID. With the
Infrastructure-SSID parameter enabled, the bridge ensures that a non-native VLAN cannot be assigned
to that SSID.
ARP Table Is Corrupted When Multiple BVIs Are Configured
The bridge supports only one bridge virtual interface (BVI). Multiple BVIs should not be configured
because the ARP table may become corrupted.
because the ARP table may become corrupted.