Cisco Cisco Aironet 1310 Access Point Bridge Guide De Montage

Pole or tower mounting requires U bolts that fit the pole or mast in use. One source is One source is 
McMaster-Carr’s web site.

Document all the necessary tools, parts, brackets, hardware and accessories that are required for the 
installation and make sure you have them all before starting.

When you are deploying a wireless access point link through a window, the window glass can introduce 
significant signal loss. Typical losses range from 5 to 15 dB per window, depending upon the type of 
glass. Deployment planning should take this extra loss into account conservatively when planning 
antenna gains and power settings. A thorough site survey is critical for deployments that require 
penetration through windows.

For additional information on a window mounting bracket, refer to the following URL:

Many types of window glass allow radio signals to pass through easily while some types greatly restrict 
radio signals. These are some general guidelines for operating through window glass:

Avoid glass with metallic content or metallic coatings

Avoid glass with conductive gas between the panes

Avoid glass with embedded wire

Select windows at roughly the same height at both ends

Select windows with the least thickness

Ensure that radio signal quality tests are conducted through the glass before finalizing the site 
selection

The access point can be mounted above a suspended ceiling in environmental air space using the wall or 
ceiling mounting bracket (refer to the 

).

The access point and power injector have adequate fire resistance and low smoke-producing 
characteristics to make them suitable for operation in a building's environmental air space (such as above 
suspended ceilings) in accordance with Section 300-22(C) of the National Electrical Code (NEC). 

When mounting the access point or power injector in a building's environmental air space, you must use 
coax and Ethernet cables suitable for operation in environmental air space in accordance with Section 
300-22(C) of the National Electrical Code (NEC). 

The power module is not rated for mounting above suspended ceilings.