Cisco Cisco Aironet 1310 Access Point Bridge Guide De Montage

Cut the cables to length, install F-connectors on the ends, and connect them to the grounding block.

To prevent damage to the access point or power injector, connect all coax cables from the 
power injector to the access point and connect the power jack to the power injector before 
applying power.

The grounding block must be connected to the building's grounding electrode system by 
14 AWG copper wire or larger.

Find the building's grounding electrode system and then connect the access point ground lug to it using 
6 AWG copper wire. Use a crimping tool to crimp the wire to the ground lug. For more information about 
attaching the ground lug to the access point, see 

 in the 

 for the ground lug location.

To ensure correct installation and grounding, install the access point in compliance with your 
local and national electrical codes: National Fire Protection Association (NFPA) 70, National 
Electrical Code (U.S.); Canadian Electrical Code, Part I, CSA 22.1 (Canada); and if local or 
national electrical codes are not available, refer to IEC 364, Part I through Part 7 (other 
countries).

Local code may require grounding of the rooftop mount.

For outdoor locations, weather seal all coaxial connectors by wrapping them with the sealant tape 
provided with the installation kit. For more information, see the 

.

A professional installer must install the access point on a tower. A professional installer has skills and 
knowledge related to the construction, operation, and installation of electrical equipment and has 
received safety training on the hazards involved.

Installing the access point on a tower includes the following subtasks:

Mounting the access point

Routing the cables (normal or lightning protected)

Activating the link

This warning applies to outdoor access point installations.

Only trained and qualified personnel should be allowed to install, replace, or service this equipment. 
Statement 1030