Cisco Cisco AMP Threat Grid 5000 Appliance Guide De Montage
Cisco AMP Threat Grid Appliance Setup and Configuration Guide
SERVER SETUP
SERVER SETUP
11
Figure 4 - Cisco UCS C220 M3 Rear View Details
Note:
For releases 1.0-1.2 a reboot may be needed if an interface was not plugged in at boot time. This is a pre-
1.3 issue, except for any interface requiring an SFP, which will still needs to be plugged in at boot time post 1.3.
The network cable plugged into the SFP may be hot-plugged safely.
The network cable plugged into the SFP may be hot-plugged safely.
Network Interface Setup Diagram
This section describes the most logical/recommended setup for an AMP Threat Grid Appliance. However, each
customer's interface setup is different. Depending on your network requirements, you may well decide to connect
the Dirty interface to the inside, or the Clean interface to the outside with appropriate network security measures
in place, for example.
customer's interface setup is different. Depending on your network requirements, you may well decide to connect
the Dirty interface to the inside, or the Clean interface to the outside with appropriate network security measures
in place, for example.