Cisco Cisco Packet Data Gateway (PDG)
hsgw-service
Creates an HSGW service or specifies an existing HSGW service and enters the HSGW Service Configuration
Mode for the current context.
Mode for the current context.
Product
HSGW
Privilege
Administrator
Command Modes
Exec > Global Configuration > Context Configuration
configure > context context_name
Entering the above command sequence results in the following prompt:
[
context_name
]
host_name
(config-ctx)#
Syntax Description
hsgw-service service_name [ -noconfirm ]
no hsgw-service service_name
no hsgw-service service_name
no
Removes the specified HSGW service from the context.
service_name
Specifies the name of the HSGW service. If service_name does not refer to an existing service, the new service
is created if resources allow. service_name is an alphanumeric string of 1 through 63 characters.
is created if resources allow. service_name is an alphanumeric string of 1 through 63 characters.
Service names must be unique across all contexts within a chassis.
Important
-noconfirm
Executes the command without any additional prompt and confirmation from the user.
Usage Guidelines
Enter the HSGW Service Configuration Mode for an existing service or for a newly defined service. This
command is also used to remove an existing service.
command is also used to remove an existing service.
A maximum of 256 services (regardless of type) can be configured per system.
Command Line Interface Reference, Modes C - D, StarOS Release 19
665
Context Configuration Mode Commands E-H
hsgw-service