Cisco Cisco Packet Data Gateway (PDG)
private [ priority ]
Address pool may only be used by mobile stations which have requested an IP address from a specified pool.
When private pools are part of an IP pool group, they are used in a priority order according to the precedence
setting. priority must be an integer from 0 through 10 with 0 being the highest priority. The default value is
0.
When private pools are part of an IP pool group, they are used in a priority order according to the precedence
setting. priority must be an integer from 0 through 10 with 0 being the highest priority. The default value is
0.
public [ priority ]
Address pool is used in priority order for assigning IP addresses to mobile stations which have not requested
a specific address pool. priority must be an integer from 0 through 10 with 0 being the highest priority. The
default value is 0.
a specific address pool. priority must be an integer from 0 through 10 with 0 being the highest priority. The
default value is 0.
static
Designates local IP address pool to statically assign pooled addresses.
The keyword static must be used for DHCP served IP addresses.
Important
tag { none | pdif-setup-addr }
Default: none
none: default tag for all IP address pools
pdif-setup-addr:pool with this tag should only be used for PDIF calls.
address-hold-timer seconds
When this is enabled, and an active subscriber is disconnected, the IP address is held or considered still in
use, and is not returned to the free state until the address-hold-timer expires. This enables subscribers who
reconnect within the length of time specified (in seconds) to obtain the same IP address from the IP pool.
use, and is not returned to the free state until the address-hold-timer expires. This enables subscribers who
reconnect within the length of time specified (in seconds) to obtain the same IP address from the IP pool.
seconds is the time in seconds and must be an integer from 0 through 31556926.
For releases prior to 20.0, a change made to the IP pool hold timer takes immediate effect on existing
addresses currently on hold. Timeouts are adjusted to align with the new value. For releases after 20.0,
the new timeout value will only be applied to addresses which are put on hold in the future. Timeouts for
addresses currently in the hold state are not modified. They will timeout using the original timeout value.
addresses currently on hold. Timeouts are adjusted to align with the new value. For releases after 20.0,
the new timeout value will only be applied to addresses which are put on hold in the future. Timeouts for
addresses currently in the hold state are not modified. They will timeout using the original timeout value.
Important
Currently, the address-hold-timer only supports IPv4 addresses.
Important
address-quarantine-timer seconds
Specifies the timer value in seconds for an address quarantine timer as an integer from 20 through 86400.
This timer cannot be configured with an address-hold-timer in the same pool.
This timer cannot be configured with an address-hold-timer in the same pool.
The IP pool address-quarantine-timer is a mechanism to busy out a released IP address for a specified interval.
This prevents an IP address from being reused until the quarantine timer expires.
This prevents an IP address from being reused until the quarantine timer expires.
Command Line Interface Reference, Modes C - D, StarOS Release 19
714
Context Configuration Mode Commands I-M
ip pool