Cisco Cisco Tunnel Terminating Gateway (TTG)
Specifies peer selection based on International Mobile Subscriber Identification (IMSI) range.
start-value imsi_start_value specifies the start of range in integer value of IMSI, and end-value imsi_end_value
specifies the end of range in integer value of IMSI.
specifies the end of range in integer value of IMSI.
imsi-based { { prefix | suffix } imsi/prefix/suffix_start_value } [ to imsi/prefix/suffix_end_value ]
This section applies only to 9.0 and later releases for UMTS deployments.
Important
Selects peer based on IMSI prefix or suffix or IMSI range.
prefix: Specifies the prefix range
suffix: Specifies the suffix range
imsi/prefix/suffix_start_value: Specifies the IMSI/prefix/suffix start value. prefix/suffix must be an IMSI
prefix/suffix, and must be an integer from 1 through 15 characters.
prefix/suffix, and must be an integer from 1 through 15 characters.
imsi/prefix/suffix_end_value: Specifies the IMSI/prefix/suffix end value. prefix/suffix must be an IMSI
prefix/suffix, and must be an integer from 1 through 15 characters that must be greater than the start value.
prefix/suffix, and must be an integer from 1 through 15 characters that must be greater than the start value.
If prefix/suffix is used, the lengths of both start and end prefix/suffix must be equal. If the prefix or suffix
keyword is not specified, it will be considered as suffix.
keyword is not specified, it will be considered as suffix.
Important
msisdn-based { { prefix | suffix } msisdn/prefix/suffix_start_value } [ to msisdn/prefix/suffix_end_value ]
Specifies peer selection based on MSISDN prefix or suffix or MSISDN range.
prefix: Specifies the prefix range
suffix: Specifies the suffix range
msisdn/prefix/suffix_start_value: Specifies the MSISDN/prefix/suffix start value. prefix/suffix must be an
MSISDN prefix/suffix, and must be an integer from 1 through 15 characters.
MSISDN prefix/suffix, and must be an integer from 1 through 15 characters.
msisdn/prefix/suffix_end_value: Specifies the MSISDN/prefix/suffix end value. prefix/suffix must be an
MSISDN prefix/suffix, and must be an integer from 1 through 15 characters that must be greater than the start
value.
MSISDN prefix/suffix, and must be an integer from 1 through 15 characters that must be greater than the start
value.
realm realm_name
The realm_name must be an alphanumeric string of 1 through 127 characters, and can contain punctuation
characters. The realm may typically be a company or service name.
characters. The realm may typically be a company or service name.
secondary-peer secondary_peer_name
Specifies a name for the secondary host to be used for failover processing. When the route-table does not find
an AVAILABLE route, the secondary host performs a failover processing if the
an AVAILABLE route, the secondary host performs a failover processing if the
command is set.
secondary_peer_name must be an alphanumeric string of 1 through 63 characters, and can contain punctuation
characters.
characters.
Usage Guidelines
Use this command to configure Diameter credit control host selection.
Command Line Interface Reference, Modes C - D, StarOS Release 19
1019
Credit Control Configuration Mode Commands
diameter peer-select