Cisco Cisco Tunnel Terminating Gateway (TTG)
threshold-rate
Configures the rate per second at which the system must receive authorization failures or bad registration
requests before it considers the failures/requests a DoS attack.
requests before it considers the failures/requests a DoS attack.
The system will ignore the configuration of this command unless the dos-prevention command has been
enabled.
enabled.
Important
Product
SCM (P-CSCF, A-BG)
Privilege
Security Administrator, Administrator
Command Modes
Exec > Global Configuration > Context Configuration > CSCF Service Configuration > Proxy-CSCF
Configuration > CSCF Security Configuration
Configuration > CSCF Security Configuration
configure > context context_name > cscf service service_name > proxy-cscf > security-parameters
Entering the above command sequence results in the following prompt:
[
context_name
]
host_name
(config-security-parameters)#
Syntax Description
threshold-rate rate
default threshold-rate
default threshold-rate
default
Sets/restores the default value assigned to the specified command.
rate
Default: 1
Specifies the rate per second that the system must receive authorization failures or bad registration requests
to determine that it is under a DoS attack.
to determine that it is under a DoS attack.
rate must be an integer from 1 to 1,000.
Usage Guidelines
Use this command to specify the threshold rate for authorization failures or bad registration requests. For
example, if a malicious user sends bad registration requests at a rate of 5 per second and this parameter is set
to 10, the system will not consider itself under a DoS attack.
example, if a malicious user sends bad registration requests at a rate of 5 per second and this parameter is set
to 10, the system will not consider itself under a DoS attack.
Command Line Interface Reference, Modes C - D, StarOS Release 19
1608
CSCF Security Configuration Mode Commands
threshold-rate