Cisco Cisco Tunnel Terminating Gateway (TTG)
In release 16.0, a warning message is displayed if the user tries to configure a value greater than 100 and
the max-outstanding is configured as 100. This is because there is an internal limit of up to 100 max
outstanding requests that can be configured.
the max-outstanding is configured as 100. This is because there is an internal limit of up to 100 max
outstanding requests that can be configured.
Important
priority priority
Default:1000
Specifies the relative priority of this CGF. When multiple CGFs are configured, the priority is used to determine
which CGF server to send accounting data to.
which CGF server to send accounting data to.
priority can be configured as an integer from 1 through 1000. When configuring two or more servers with
the same priority you will be asked to confirm that you want to do this. If you use the -noconfirm option, you
are not asked for confirmation and multiple servers could be assigned the same priority.
the same priority you will be asked to confirm that you want to do this. If you use the -noconfirm option, you
are not asked for confirmation and multiple servers could be assigned the same priority.
port port
Default: 3386
Specifies the port the CGF is using. port can be configured as an integer from 1 through 65535. Default value
for port is 3286.
for port is 3286.
The port keyword option has been modified from udp-port to make it a generic command. The udp-port
keyword can still be used, however, it will be in concealed mode and will not be shown in auto-complete
or help for the command.
keyword can still be used, however, it will be in concealed mode and will not be shown in auto-complete
or help for the command.
Important
node-alive { enable | disable }
Default: Disable.
This optional keyword allows operator to enable/disable GSN to send Node Alive Request to GTPP Server
(i.e. CGF). This configuration can be done per GTPP Server basis.
(i.e. CGF). This configuration can be done per GTPP Server basis.
-noconfirm
Executes the command without any additional prompt and confirmation from the user.
Usage Guidelines
Use this command to configure the CGF(s) that the system sends CDR accounting data to.
Multiple CGFs can be configured using multiple instances of this command. Up to 12 CGF scan be configured
per system context. Each configured CGF can be assigned a priority. The priority is used to determine which
server to use for any given subscriber based on the routing algorithm that has been implemented. A CGF with
a priority of "1" has the highest priority.
per system context. Each configured CGF can be assigned a priority. The priority is used to determine which
server to use for any given subscriber based on the routing algorithm that has been implemented. A CGF with
a priority of "1" has the highest priority.
The configuration of multiple CGFs with the same IP address but different port numbers is not supported.
Important
Each CGF can also be configured with the maximum allowable number of unacknowledged GTPP packets.
Since multiple AAA Manager tasks could be communicating with the same CGF, the maximum is based on
Since multiple AAA Manager tasks could be communicating with the same CGF, the maximum is based on
Command Line Interface Reference, Modes C - D, StarOS Release 19
638
Context Configuration Mode Commands E-H
gtpp server