Cisco Cisco Packet Data Interworking Function (PDIF)
protocol ldp
Creates or removes the MPLS label distribution protocol (LDP) configuration, or configures an existing
protocol and enters the MPLS-LDP Configuration Mode in the current context. This command configures
the protocol parameters for MPLS LDP.
protocol and enters the MPLS-LDP Configuration Mode in the current context. This command configures
the protocol parameters for MPLS LDP.
Product
GGSN
P-GW
SAEGW
Privilege
Security Administrator, Administrator
Command Modes
Exec > Global Configuration > Context Configuration > MPLS-IP Configuration
configure > context context_name > mpls-ip
Entering the above command sequence results in the following prompt:
[
context_name
]
host_name
(config-mpls)#
Syntax Description
[ no ] protocol ldp
no
Removes the configured MPLS-LDP mode from MPLS-IP Configuration mode.
Usage Guidelines
Use this command to create/ or remove the MPLS LDP configuration, or configure an existing protocol. If
required mode already exists it enters the MPLS-LDP Configuration Mode in the current context.
required mode already exists it enters the MPLS-LDP Configuration Mode in the current context.
Entering this command results in the following prompt:
[
context_name
]
hostname
(config-ldp)#
The commands configured in this mode are defined in the MPLS-LDP Configuration Mode Commands chapter.
Examples
The following command creates and enters the MPLS-LDP Protocol mode:
protocol ldp
protocol ldp
Command Line Interface Reference, Modes I - Q, StarOS Release 19
1008
MPLS-IP Configuration Mode Commands
protocol ldp