Cisco Cisco Packet Data Gateway (PDG)
Call Control Profile Configuration Mode
samog-gtpv1 ▀
Command Line Interface Reference, StarOS Release 18 ▄
2095
samog-gtpv1
Enables SaMOG to forward the User Equipment's (UE) Identity and/or the Access Point's (AP) Location information
over the GTPv1 interface.
over the GTPv1 interface.
Product
SaMOG
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration > Call Control Profile Configuration
configure > call-control-profile profile_name
Entering the above command sequence results in the following prompt:
[local]host_name(config-call-control-profile-profile_name)#
Syntax
samog-gtpv1 send { imeisv value ue-mac [ filler filler_value ] | uli value cgi }
no samog-gtpv1 send { imeisv | uli }
no
If configured, disables SaMOG from forwarding the UE Identity and/or AP Location information over the
GTPv1 interface.
GTPv1 interface.
imeisv value ue-mac [ filler filler_value ]
Specifies to forward the UE Identity. By default this configuration is disabled.
filler
: Specifies the 2 bytes of padding to be used with the UE's MAC address for the IMEIsV IE value.
filler_value
must be a hexadecimal number from 0x0 through 0xFFFE. The default filler value is
0xFFFF.
uli value cgi
Specifies to forward the AP's User Location Information (ULI) IE during the PDP context setup.
Usage
Use this command to enable SaMOG to forward the User Equipment's (UE) Identity and/or the Access
Point's (AP) Location information over the GTPv1 interface.
Point's (AP) Location information over the GTPv1 interface.
Example
Configure SaMOG to forward the AP location information :
samog-gtpv1 uli value cgi