Cisco Cisco Packet Data Interworking Function (PDIF)
HNB-GW Service Configuration Mode Commands
▀ hnb-access-mode open
▄ Command Line Interface Reference, StarOS Release 18
6458
Usage
Use this command to configure the HNB-GW service instance for Open Access Mode support and related
parameters.
This command enable Open Access mode support to allow the UEs that can register from an Open HNB. If a
UE tries to register from an Open HNB with an HNB-GW service instance, which is already reached to the
limit configured through
parameters.
This command enable Open Access mode support to allow the UEs that can register from an Open HNB. If a
UE tries to register from an Open HNB with an HNB-GW service instance, which is already reached to the
limit configured through
max-registered-ue
reg_ue_open
the HNB-GW sends HNB-Registration-
Reject message with “ue not allowed in this hnb” cause.
Important:
If Operator has reduced the maximum number of UEs allowed per Open HNB during the session,
this will not have any effect on already registered UEs/CS-Calls/PS-Calls even if previously configured
reg_ue_open
is beyond the newly configured
reg_ue_open
value. Limits is respected while handling new requests.
Example
The following command configures the HNB-GW service instance to allow 16 UEs to register through an
open HNB:
open HNB:
hnb-access-mode open max-registered-ue 16