Cisco Cisco Packet Data Interworking Function (PDIF)
IuPS Service Configuration Mode Commands
plmn ▀
Command Line Interface Reference, StarOS Release 18 ▄
6871
plmn-list mcc mcc_num mnc mnc_num
When network sharing is employed and more than two PLMNs are available, then use the
plmn-list
keyword to begin a list of all additional PLMNs.
Usage
Use this command to configure the PLMN associated with the SGSN. There can only be one PLMN
associated with an SGSN unless one of the following features is enabled and configured: network sharing or
multiple PLMN.
For network sharing, use of the
associated with an SGSN unless one of the following features is enabled and configured: network sharing or
multiple PLMN.
For network sharing, use of the
network-sharing
keywords make it possible to identify more than one
PLMN. Including the PLMN identified initially. None have precedence. They are all treated equally but they
must each be unique. In a MOCN configuration, the PLMN list will not be used as there would only be one
local PLMN.
For multiple PLMN support, the SGSN can support up to 8 Iu-PS configurations for PLMNs. These Iu-PS
service configurations must be associated with the SGSN via the
must each be unique. In a MOCN configuration, the PLMN list will not be used as there would only be one
local PLMN.
For multiple PLMN support, the SGSN can support up to 8 Iu-PS configurations for PLMNs. These Iu-PS
service configurations must be associated with the SGSN via the
ran-protocol
command in the SGSN
Service configuration mode.
Example
Use the following command to identify a PLMN by the MCC
313
and MNC
23
and instruct the SGSN to
perform network sharing with a single
common PLMN
identified by MCC
404
and MNC
123
:
plmn id mcc 313 mnc 23 network-sharing common-plmn mcc 404 mnc 123