Cisco Cisco ASR 5700
Call Control Profile Configuration Mode
attach restrict ▀
Command Line Interface Reference, StarOS Release 17 ▄
1909
tracking-area-not-allowed
The default cause code is
no-suitable-cell-in-tracking-area
.
Important:
The
tracking-area-not-allowed
cause code is not supported for the MME.
Important:
The
roaming-not-allowed-in-this-tracking-area
and
tracking-area-not-allowed
cause codes are not applicable for use with the
imsi-attach-fail
or
voice-unsupported
keywords.
imsi-attach-fail
Directs the MME to restrict EPS attach when IMSI attach fails. If the policy is configured, all IMSI failures
will result in a EPS restriction.
The default cause code for calls rejected for imsi-attach-fail is
will result in a EPS restriction.
The default cause code for calls rejected for imsi-attach-fail is
no-suitable-cell-in-tracking-area
.
voice-unsupported
Directs the MME to restrict EPS attach when voice is not supported, such as when Voice over IMS is not
supported and the UE does not support Circuit Switched Fall Back (CSFB).
This setting is applicable when all of the following conditions apply:
supported and the UE does not support Circuit Switched Fall Back (CSFB).
This setting is applicable when all of the following conditions apply:
The UE is voice-centric as determined in the UE usage setting of the Voice Domain and UE Settings IE
sent in the request.
The UE does not support CSFB as determined in the EMM Combined procedures Capability bit of the
MS Network Capability IE sent in the request, OR if CSFB is not supported on the MME as
determined by the SGs service not being associated with the MME service.
determined by the SGs service not being associated with the MME service.
Voice over IMS is not supported in the network as defined by the
network-feature-support-ie
ims-voice-over-ps
command.
The default cause code for calls rejected for voice-unsupported is
no-suitable-cell-in-tracking-
area
.
all
Instructs the system to apply the command action to all location area lists. Location area lists should already
have been created with the
have been created with the
location-area-list
command. The location area list consists of one or more
LACs, location area codes, where the MS is when placing the call.
location-area-list instance
list_id
Instructs the SGSN to apply the command action to a specific location area list. Location area lists should
already have been created with the
already have been created with the
location-area-list
command. The location area list consists of one
or more LACs, location area codes, where the MS is when placing the call.
Using this keyword with either the
Using this keyword with either the
allow
or
restrict
keywords enables you to configure with more
granularity.
list_id
: Enter an integer between 1 and 5.
Important:
This keyword only applies to the SGSN.