Cisco Cisco ASR 5700
Exec Mode Commands (D-S)
port switch to ▀
Command Line Interface Reference, StarOS Release 17 ▄
4131
port switch to
Performs a manual switchover to an available redundant/standby line card, SPIO port, or MIO port.
Default: none.
Product
All
Privilege
Security Administrator, Administrator, Operator
Mode
Exec
The following prompt is displayed in the Exec mode:
[local]host_name#
Syntax
port switch to slot# / port#
slot#
Identifies the physical chassis slot where the line card,r SPIO, or MIO card is installed.
port#
Identifies the physical port on the line card, SPIO, or MIO to automatically switch to.
Usage
This command is used to specify the redundant port on a Line Card (LC) or MIO. When port redundancy is
enabled, if an external network device or cable failure occurs that causes a link down failure on the port, then
the redundant port is used.
enabled, if an external network device or cable failure occurs that causes a link down failure on the port, then
the redundant port is used.
Important:
This command is not supported on all platforms.
Example
port switch to 17/1
port switch to 6/11