Cisco Cisco ASR 5700
Call Control Profile Configuration Mode
rau-inter ▀
Command Line Interface Reference, StarOS Release 17 ▄
2051
allow access-type
Including this keyword with one of the following options, configures the SGSN to allow MS/UE with the
identified access-type extension to be part of the intra-RAU procedure.
identified access-type extension to be part of the intra-RAU procedure.
gprs
- General Packet Radio Service
umts
- Universal Mobile Telecommunications System
avoid-s12-direct-tunnel
Enables the operator to modify the Call-Control profile default configuration and instructs the SGSN to avoid
establishment of a direct tunnel for S12 interfaces.
This keyword is only supported for configuration of S12 interfaces.
establishment of a direct tunnel for S12 interfaces.
This keyword is only supported for configuration of S12 interfaces.
ctxt-xfer-failure fail_code
Configure or removes a GMM failure cause code to be sent in a RAU Reject to the UE due to context transfer
failures.
failures.
fail_code
For acceptable options, refer to the failure-codes listed below.
remove
filter works with this keyword to erase the context transfer failure cause code definition.
exclude-uteid-in-mbr
By default, the SGSN sends user plane fully qualified tunnel end-point identifier (UTEID) in the Modify
Bearer Reqeust (MBR). If RABs are not yet established, this keyword disables or enables the sending of the
UTEID in the MBR during a new SGSN RAU over S16/S3. This keyword is in compliance with 3GPP TS
23.401 v11.8.0.
Bearer Reqeust (MBR). If RABs are not yet established, this keyword disables or enables the sending of the
UTEID in the MBR during a new SGSN RAU over S16/S3. This keyword is in compliance with 3GPP TS
23.401 v11.8.0.
ignore-peer-context-id
Sets the SGSN to ignore the peer's context-ID and replace with PDP context-ID information based on the
HLR subscription.
HLR subscription.
peer-sgsn-addr-resolution-failure fail_code
Configure or remove a GMM failure cause code to be sent in a RAU Reject to the UE due to peer address
resolution failures at the SGSN.
resolution failures at the SGSN.
fail_code
Enter either 9 (MSID cannot be derived by the network) or 10 (Implicitly detached) to identify
the GMM failure cause code.
remove
filter works with this keyword to erase the failure code definition.
restrict access-type
Including this keyword-set with one of the following options, configures the SGSN to restrict MS/UE with
the identified access-type extension from the inter-RAU procedure.
the identified access-type extension from the inter-RAU procedure.
gprs
- General Packet Radio Service
umts
- Universal Mobile Telecommunications System
all
all -
adding this option to the keyword determines that the failure cause code will be applicable to all
location areas.