Cisco Cisco Packet Data Interworking Function (PDIF)
Exec Mode Commands (D-S)
monitor subscriber ▀
Command Line Interface Reference, StarOS Release 17 ▄
4117
Event ID information
Inbound events
Outbound events
Protocols (identical to those monitored by command)
Once the criteria has been selected, the utility will monitor and display every relative piece of information on
the subscriber(s).
For additional information on using the monitor utility, refer to the System Administration Guide.
the subscriber(s).
For additional information on using the monitor utility, refer to the System Administration Guide.
Important:
Option Y for performing multi-call traces is only supported for use with the GGSN. This option is
available when monitoring is performed using the “Next-Call” option. It allows you monitor up to 11 primary PDP
contexts for a single subscriber.
contexts for a single subscriber.
Subscriber monitoring is performed on a context-by-context-basis. Therefore, the information displayed will
be only that which is collected within the system context from which the utility was executed.
be only that which is collected within the system context from which the utility was executed.
Caution:
Subscriber monitoring can be intrusive to subscriber sessions and could impact system performance;
therefore, it should only be used as a troubleshooting tool.
Example
The following command enables monitoring for user
user1
.
monitor subscriber username user1
The following command will enable monitoring for the user assigned IP address
10.2.3.4
.
monitor subscriber ip-address 10.2.3.4
The following enables monitoring for call ID
FE80AA12
.
monitor subscriber callid fe80aa12