Cisco Cisco Tunnel Terminating Gateway (TTG)
Exec Mode show Commands (H-L)
show henbgw ▀
Command Line Interface Reference, StarOS Release 17 ▄
4591
call-idcall_id
call-id
: This is specific Call Identification Number. This must be followed by
call_id
, an eight digit
HEX number.
full
This command displays information on session state for matching sessions
qci qci_value
call-id
: This is specific qci value. Displays henbgw sessions for QCI value. This must be followed by
qci_value
, an integer between 1 and 9.
s1-peer s1_peer_address
s1-peer
: This is specific S1 peer. Must be followed by the IPv4 or IPv6 address of a peer eNodeB.
s1_peer_address
is an IPv4 address, using dotted-decimalnotation 0r an IPv6 address, using xx:yy::zz
format.
summary
This command displays summary information covering matching sessions.
ue
Displays UE information.
| { grep
grep_options
|
more }
Pipes (sends) the output of this command to the specified command. You must specify a command to which
the output of this command will be sent.
For details on the usage of
the output of this command will be sent.
For details on the usage of
grep
and
more
, refer to the Regulating a Command’s Output section of the
Command Line Interface Overview chapter.
Usage
Use this command to displays HENBGW service related information.
Example
The following command displays information for all HENB associations :
show henbgw henb-association all