Cisco Cisco Tunnel Terminating Gateway (TTG)
HNB-GW Service Configuration Mode Commands
paging open-hnb ▀
Command Line Interface Reference, StarOS Release 17 ▄
6385
never
: Sets the system to page the open HNBs from where the UE is registered. If the UE is not registered
then it NEVER pages any open HNB.
only-if-with-paging-area
: Sets the system to ALWAYS page the open HNBs from where the UE is
registered. If the UE is not registered then it pages the open HNBs only when paging-area IE is received in
paging messages.
paging messages.
Usage
Use this command to configure the paging optimization parameters for open HNBs connected through Open
Access mode in HNB-GW service instance.
Access mode in HNB-GW service instance.
Example
The following command configures the HNB-GW service instance to page an open HNB from where the UE
is connected and paging-area IE is received in paging message:
is connected and paging-area IE is received in paging message:
paging open-hnb hnb-where-ue-registered fallback only-if-with-paging-area