Cisco Cisco Packet Data Interworking Function (PDIF)
Ethernet Port Configuration Mode Commands
▀ threshold high-activity
▄ Command Line Interface Reference, StarOS Release 16
3654
threshold high-activity
Configures thresholds for high port activity for the port.
Product
All
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration > Ethernet Port Configuration
configure > port ethernet slot_number/port_number
Entering the above command sequence results in the following prompt:
[local]host_name(config-port-slot_number/port_number)#
Syntax
threshold high-activity high_thresh [ clear low_thresh ]
high_thresh
Specifies the high threshold high port activity percentage that must be met or exceeded within the polling
interval to generate an alert or alarm. The percentage is expressed as an integer from 0 through 100. Default:
50
interval to generate an alert or alarm. The percentage is expressed as an integer from 0 through 100. Default:
50
clear
Allows the configuration of the low threshold.
low_thresh
Specifies the low threshold high port activity percentage that maintains a previously generated alarm
condition. If the activity percentage falls below the low threshold within the polling interval, a clear alarm
will be generated. The percentage is expressed as an integer from 0 through 100. Default: 50
condition. If the activity percentage falls below the low threshold within the polling interval, a clear alarm
will be generated. The percentage is expressed as an integer from 0 through 100. Default: 50
Important:
This value is ignored for the Alert model. In addition, if this value is not configured for the Alarm
model, the system assumes it is identical to the high threshold.
Usage
High port activity thresholds generate alerts or alarms based on the utilization percentage of each configured
port during the specified polling interval. This threshold is configured on a per-port basis.
Alerts or alarms are triggered for high port activity based on the following rules:
port during the specified polling interval. This threshold is configured on a per-port basis.
Alerts or alarms are triggered for high port activity based on the following rules:
Enter condition: Actual percent utilization of a port is greater than High Threshold.
Clear condition: Actual percent utilization of a port is less than Low Threshold.
If a trigger condition occurs within the polling interval, the alert or alarm will not be generated until the end
of the polling interval.
of the polling interval.