Cisco Cisco Packet Data Interworking Function (PDIF)
Policy Control Configuration Mode Commands
event-update ▀
Command Line Interface Reference, StarOS Release 16 ▄
7873
apn-ambr-mod-failure — APN AMBR Modification Failure event trigger
bearer-loss — Loss of bearer trigger
bearer-rcvry — Recovery of bearer trigger
charging-correlation-exchange — Charging Correlation Exchange trigger
default-bearer-qos-change — Default EPS bearer QoS change event trigger
default-bearer-qos-mod-failure — Default EPS Bearer QOS Modification Failure event trigger
ip-can-change — IP-CAN Change trigger
out-of-credit — Out of credit trigger
pgw-trace-control — P-GW Trace Control
plmn-change — PLMN change trigger
qos-change — QoS change trigger
qos-excess-change — Qos Change Exceeding Authorization trigger
rai-change — RAI Change trigger
rat-change — RAT change trigger
reallocation-of-credit — Reallocation of credit trigger
resource-modification-request — Resource modification trigger
revalidation-timeout — Revalidation timeout trigger
sgsn-change — SGSN change trigger
successful-resource-alloc — Successful Resource Allocation event trigger
tft-change — TFT change trigger
ue-ip-addr-allocate — UE IP address allocate trigger
ue-ip-addr-release — UE IP address release trigger
ue-timezone-change — UE Time Zone Change event trigger
user-loc-change — User Location Change trigger
Usage
Use this command to send volume usage information when an event change is reported to the PCRF in a
CCR-U message.
To send customized usage information based on specific event triggers, the event should be accordingly
configured with the
CCR-U message.
To send customized usage information based on specific event triggers, the event should be accordingly
configured with the
event-update send-usage-report events
command. For example, if the usage
report is required whenever RAT change occurs, this can be accomplished using the
event-update send-
usage-report events rat-change
command.
Example
The following command specifies to send volume usage report in event updates to the PCRF for all event
triggers:
triggers:
event-update send-usage-report reset-usage
The following command specifies to send volume usage report in event updates to the PCRF for RAT change
scenarios:
scenarios:
event-update send-usage-report reset-usage events rat-change