Cisco Cisco Tunnel Terminating Gateway (TTG)
GTPP Server Group Configuration Mode Commands
▀ gtpp server
▄ Command Line Interface Reference, StarOS Release 16
6008
Specifies the relative priority of this CGF as an integer from 1 through 1000. When multiple CGFs are
configured, the priority is used to determine which CGF server to send accounting data to. When configuring
two or more servers with the same priority you will be asked to confirm that you want to do this.
If you use the -noconfirm option, you are not asked for confirmation and multiple servers could be assigned
the same priority.
configured, the priority is used to determine which CGF server to send accounting data to. When configuring
two or more servers with the same priority you will be asked to confirm that you want to do this.
If you use the -noconfirm option, you are not asked for confirmation and multiple servers could be assigned
the same priority.
udp-portport
Specifies the UDP port over which the GGSN communicates with the CGF. as an integer from 1 through
65535. Default: 3386
65535. Default: 3386
node-alive { enable | disable }
Enable or disables GGSN sending Node Alive Request to a GTPP Server (such as CGF). This configuration
can be done per GTPP Server. Default: Disable.
can be done per GTPP Server. Default: Disable.
-noconfirm
Executes this command without any additional prompt and confirmation from the user.
Usage
Use this command to configure the CGF(s) that the system sends CDR accounting data to.
Multiple CGFs can be configured using multiple instances of this command subject to the following limits:
Multiple CGFs can be configured using multiple instances of this command subject to the following limits:
Up to 4 CGFs can be configured in one GTPP server group
Total of 32 CGFs can be configured per context.
Each configured CGF can be assigned a priority. The priority is used to determine which server to use for any
given subscriber based on the routing algorithm that has been implemented. A CGF with a priority of “1” has
the highest priority.
given subscriber based on the routing algorithm that has been implemented. A CGF with a priority of “1” has
the highest priority.
Important:
The configuration of multiple CGFs with the same IP address but different port numbers is not
supported.
Each CGF can also be configured with the maximum allowable number of unacknowledged GTPP packets.
Since multiple AAA Manager tasks could be communicating with the same CGF, the maximum is based on
any one AAA Manager instance. If the maximum is reached, the system buffers the packets Random Access
Memory (RAM). The system allocates memory as a buffer, enough to store one million CDRs for a fully
loaded chassis (a maximum of one outstanding CDR per PDP context).
Since multiple AAA Manager tasks could be communicating with the same CGF, the maximum is based on
any one AAA Manager instance. If the maximum is reached, the system buffers the packets Random Access
Memory (RAM). The system allocates memory as a buffer, enough to store one million CDRs for a fully
loaded chassis (a maximum of one outstanding CDR per PDP context).
Example
The following command configures a CGF with an IP address of 192.168.2.2 and a priority of 5.
gtpp server 192.168.2.2 priority 5
The following command deletes a previously configured CGF with an IP address of 100.10.35.7:
no gtpp server 100.10.35.7