Cisco Cisco Tunnel Terminating Gateway (TTG)
OSPF Configuration Mode Commands
area virtual link intervals ▀
Command Line Interface Reference, StarOS Release 16 ▄
7321
retransmit-interval
value
Specifies the interval (in seconds) that router should wait before retransmitting a packet.
value
must be an
integer from 1 through 3600.
transmit-delay
value
Specifies the interval (in seconds) that the router should wait before transmitting a packet.
value
must be an
integer from 1 through 3600.
Usage
Use this command to set the intervals or delay types for a virtual link between an area that is connected to the
network backbone and an area that cannot be connected to the network backbone.
network backbone and an area that cannot be connected to the network backbone.
Example
The following command sets the retransmit interval for a virtual link between the OSPF areas defined by the
IP address
IP address
192.168.100.10
and the IP address
192.168.200.20
to
60
seconds:
area 192.168.100.10 virtual-link 192.168.200.20 retransmit-interval 60