Cisco Cisco ASR 5000
Operator Policy
Operator Policy Configuration ▀
SGSN Administration Guide, StarOS Release 18 ▄
Operator Policy Configuration
This section provides a high-level series of steps and the associated configuration examples to configure an operator
policy. By configuring an operator policy, the operator fine-tunes any desired restrictions or limitations needed to
control call handling per subscriber or for a group of callers within a defined IMSI range.
policy. By configuring an operator policy, the operator fine-tunes any desired restrictions or limitations needed to
control call handling per subscriber or for a group of callers within a defined IMSI range.
Most of the operator policy configuration components are common across the range of products supporting operator
policy. Differences will be noted as they are encountered below.
policy. Differences will be noted as they are encountered below.
Important:
This section provides a minimum instruction set to implement operator policy. For this feature to be
operational, you must first have completed the system-level configuration as described in the System Administration
Guide and the service configuration described in your product’s administration guide.
Guide and the service configuration described in your product’s administration guide.
The components can be configured in any order. This example begins with the call control profile:
Step 1
Create and configure a call control profile, by applying the example configuration presented in the Call Control Profile
Configuration section.
Configuration section.
Step 2
Create and configure an APN profile, by applying the example configuration presented in the APN Profile
Configuration section.
Configuration section.
Important:
It is not necessary to configure both an APN profile and an IMEI profile. You can
associate either type of profile with a policy. It is also possible to associate one or more APN profiles with an
IMEI profile for an operator policy (SGSN only).
IMEI profile for an operator policy (SGSN only).
Step 3
Create and configure an IMEI profile by applying the example configuration presented in the IMEI Profile
Configuration section (SGSN only).
Configuration section (SGSN only).
Step 4
Create and configure an APN remap table by applying the example configuration presented in the APN Remap Table
Configuration section.
Configuration section.
Step 5
Create and configure an operator policy by applying the example configuration presented in the Operator Policy
Configuration section.
Configuration section.
Step 6
Configure an IMSI range by selecting and applying the appropriate product-specific example configuration presented in
the IMSI Range Configuration sections below.
the IMSI Range Configuration sections below.
Step 7
Associate the configured operator policy components with each other and a network service by applying the example
configuration in the Operator Policy Component Associations section.
configuration in the Operator Policy Component Associations section.
Step 8
Save your configuration to flash memory, an external memory device, and/or a network location using the Exec mode
command
command
save configuration
. For additional information on how to verify and save configuration files, refer to the
System Administration Guide .
Step 9
Verify the configuration for each component separately by following the instructions provided in the Verifying the
Feature Configuration section of this chapter.
Feature Configuration section of this chapter.