Cisco Cisco Tunnel Terminating Gateway (TTG)
SecGW Service Creation
▀ WSG Service Configuration
▄ SecGW Administration Guide, StarOS Release 18
40
show Commands
The following Exec mode show commands display information associated with WSG service parameters and operating
statistics. For detailed descriptions of these commands, see the Exec Mode show Commands chapter of the Command
Line Interface Reference.
statistics. For detailed descriptions of these commands, see the Exec Mode show Commands chapter of the Command
Line Interface Reference.
show wsg-lookup
This command displays the priority levels, as well as source and destination netmasks for all configured lookup
priorities. The command syntax is:
priorities. The command syntax is:
show wsg-lookup
The following is a sample output for show wsg-lookup:
wsg-lookup
priority 1 source-netmask 32 destination-netmask 32
priority 2 source-netmask 24 destination-netmask 32
priority 3 source-netmask 32 destination-netmask 24
priority 4 source-netmask 24 destination-netmask 24
show wsg-service
This command displays information about all WSG services or a specified service. It also displays statistics for a
specified WSG service or peer address.
specified WSG service or peer address.
The command syntax is:
show wsg-service ( all | name | srvc_name | statistics [ name srvc_name | peer-
address ip_address ] [ | { grep grep_options | more } ]
address ip_address ] [ | { grep grep_options | more } ]
The following is a sample output for show wsg-service name wsg01:
Servicename: wsg01
Context: wsg
Bind: Done
Max Sessions : 8000
IP address: 10.10.10.30 UDP Port: 500
MTU: 1400
Service State: Started
Crypto-template: cryptotmplt01
deployment-mode : 1