Cisco Cisco Tunnel Terminating Gateway (TTG)
show port
▀ show port info
▄ Statistics and Counters Reference, StarOS Release 18
4334
Field
Description
Configured Duplex
ASR 5x00 only
ASR 5x00 only
Indicates the port’s configured duplex mode. Possible modes are:
Auto: The port auto-detects the appropriate mode (Full- or Half-duplex) for communicating with
the network.
the network.
Full duplex
Half duplex
Configured Speed
ASR 5x00 only
ASR 5x00 only
The maximum data rate configured for this port. Possible rates are:
Auto: The port auto-detects the appropriate data rate for communicating on the network.
10 Mbps
100 Mbps
1000 Mbps (ASR 5000: supported on Ethernet 1000 Line Cards, Quad Gigabit Ethernet Line
Cards, and SPIO Cards)
Cards, and SPIO Cards)
Configured Flow
Control
ASR 5000 only
Control
ASR 5000 only
Quad Gigabit Ethernet Line Card (QGLC) only: Enabled indicates that Ethernet MAC level flow
control has been enabled for this Ethernet port. Note that this is not necessarily the operational state of
flow control, as both sides of the connection must agree to flow control during Ethernet negotiation.
control has been enabled for this Ethernet port. Note that this is not necessarily the operational state of
flow control, as both sides of the connection must agree to flow control during Ethernet negotiation.
Interface MAC
Address
ASR 5500 only
Address
ASR 5500 only
The interface media access control (MAC) address for the port.
Fixed MAC Address
ASR 5500 only
ASR 5500 only
The fixed media access control (MAC) address for the port.
MAC Address
ASR 5000 and
VPC-SI/VPC-DI
ASR 5000 and
VPC-SI/VPC-DI
The media access control (MAC) address for the port. If Virtual MAC addressing is enabled, the MAC
address is followed by (Virtual).
address is followed by (Virtual).
Boxer Interface TAP
ASR 5000 only
VPC-DI, SF only
ASR 5000 only
VPC-DI, SF only
Indicates whether this interface has been tapped for debugging or simulation purposes.
Link State
The port’s link status: Up or Down.
Link Duplex
ASR 5x00 only
ASR 5x00 only
The actual duplex mode (Auto, Full or Half) currently being used for the link.
Link Speed
ASR 5x00 only
ASR 5x00 only
The actual data rate currently being supported by the port.
Flow Control
ASR 5x00 only
ASR 5x00 only
Indicates the current negotiated state of Ethernet MAC level flow control (Enabled or Disabled. Also see
Configured Flow Control above).
Configured Flow Control above).
Link Aggregation
Group
Group
If this port is configured as part of a Link Aggregation Group (LAG), this field indicates the group number
to which this port belongs and whether the port is a Master or a Member. If the port is not configured as
part of a Link Aggregation Group, None appears in this field.
to which this port belongs and whether the port is a Master or a Member. If the port is not configured as
part of a Link Aggregation Group, None appears in this field.
(mode)
Indicates whether this LAG is redundant or non-redundant.
LAG Toggle Link
ASR 5000 only
ASR 5000 only
Yes indicates that the QGLC will generate “port link down” and “port link up” events for this LAG port.