Cisco Cisco Tunnel Terminating Gateway (TTG) Fascicule
Context Configuration Mode Commands A-D
▀ diameter authentication failure-handling
▄ Cisco ASR 5x00 Command Line Interface Reference
2258
retry-and-terminate
:First retries, if it fails then terminates the session
terminate
: Terminates the session
result-code result_code { [ to end_result_code ] action { continue | retry-and-
terminate | terminate } }
terminate | terminate } }
result_code
: Specifies the result code, must be an integer from 1 through 65535.
to end_result_code
: Specifies the upper limit of a range of result codes.
end_result_code
must be
greater than
result_code
.
action { continue | retry-and-terminate | terminate }
: Specifies action to be taken for
failures:
continue
:Continues the session
retry-and-terminate
:First retries, if it fails then terminates the session
terminate
: Terminates the session
Usage
Use this command to configure error handling for Diameter EAP, EAP-termination, and authorization
requests.Specific actions (continue, retry-and-terminate, or terminate) can be associated with each possible
result-code. Ranges of result codes can be defined with the same action, or actions can be specific on a per-
result code basis.
requests.Specific actions (continue, retry-and-terminate, or terminate) can be associated with each possible
result-code. Ranges of result codes can be defined with the same action, or actions can be specific on a per-
result code basis.
Example
The following commands configure result codes 5001, 5002, 5004, and 5005 to use
action continue
and
result code 5003 to use
action terminate
:
diameter authentication failure-handling eap-request result-code 5002 to
5005 action continue
5005 action continue
diameter authentication failure-handling eap-request result-code 5003
action terminate
action terminate