Cisco Cisco Tunnel Terminating Gateway (TTG) Fascicule
CSCF Service Configuration Mode Commands
▀ threshold
▄ Cisco ASR 5x00 Command Line Interface Reference
3150
reg-total-active
: Number of total CSCF active registrations.
Default: 0
route-failures
: Maximum number of route-failures, after which the alarm/alert will be raised. Default: 5
high_thresh
: The high threshold number that must be met or exceeded within the polling interval to
generate an alert or alarm. Can be configured to any integer value between 0 and 2000000 (0 and 60000 for
route-failures).
route-failures).
clear low_thresh
: The low threshold number that must be met or exceeded within the polling interval to
clear an alert or alarm. Can be configured to any integer value between 0 and 2000000 (0 and 60000 for
route-failures).
route-failures).
Important:
This value is ignored for the Alert model. In addition, if this value is not configured for the Alarm
model, the system assumes it is identical to the high threshold.
monitoring
Enables thresholds alerting for CSCF Service.
Usage
Use this command to:
enable/disable thresholds alerting for CSCF Service
set an alert or an alarm when a threshold exceeds the configured level
Alerts or alarms are triggered for the number of registration reply errors on the following rules:
Enter condition: Actual number > High Threshold
Clear condition: Actual number < Low Threshold
Example
The following command configures a route failures threshold of
1000
and a low threshold of
500
for a
system using the Alarm thresholding model:
threshold route-failures 1000 clear 500