Cisco Cisco Tunnel Terminating Gateway (TTG) Fascicule
Diameter Endpoint Configuration Mode Commands
▀ route-entry
▄ Cisco ASR 5x00 Command Line Interface Reference
3356
Usage
Use this command to create a route table for Diameter application.
When a Diameter client starts to establish a session with a realm/application, the system searches the route
table for the best match. If an entry has no host specified, the entry is considered to match the requested
value. Similarly, if an entry has no realm or application specified, the entry is considered to match any such
requested value. The best match algorithm is to prefer specific matches for whatever was requested, either
realm/application or host/realm/application. If there are no such matches, then system looks for route table
entries that have wildcards.
If the message’s destination realm is abc.com then the message will be routed to
When a Diameter client starts to establish a session with a realm/application, the system searches the route
table for the best match. If an entry has no host specified, the entry is considered to match the requested
value. Similarly, if an entry has no realm or application specified, the entry is considered to match any such
requested value. The best match algorithm is to prefer specific matches for whatever was requested, either
realm/application or host/realm/application. If there are no such matches, then system looks for route table
entries that have wildcards.
If the message’s destination realm is abc.com then the message will be routed to
peer1
. If the message’s
destination realm is def.com then the message will be routed to
peer2
. If the destination realm is xyz.com
then the message will be routed to “
peer-default
”.
Example
The following command creates a route entry with the host name
dcca_host1
and peer ID
dcca_peer
with
priority weight of
10
:
route-entry host dcca_host1 peer dcca_peer weight 10